TEST FOR BATTERY AND CHARGING SYSTEM PROBLEMS
An absolute necessity for your battery shop or maintenance bay, the
390PT uses patented single load, dynamic resistance technology to
completely analyze your battery and charging system quickly, safely and
accurately. You’ll provide better battery maintenance by locating the
6-Volt and 12-Volt vehicle batteries or 12-Volt and 24-Volt starting
systems that require attention while still in the vehicle. Find battery
issues before they become problems.
flooded, AGM (flat and spiral plate) and gel cell – both 6-Volt and
state of charge, cold cranking amps (CCAs) and good/bad battery
batteries IN or OUT of the vehicle
· Tests 12-Volt
and 24-Volt charging systems for proper operation
discharged batteries down to 1.5-Volts
QUICKSTART instruction guide print on the back so you can’t lose it
battery voltage and battery capacity
· Rugged shock
resistant rubber “boot” to protect your investment
· Selects from
6 languages: English, Spanish, French, German, Italian and
FAST AND EASY TO USE
1. Turn off ignition,
all accessories and loads. Close all car doors and trunk.
2. Make sure battery
terminals are clean. Attach black lead to negative battery
terminal and red lead to positive battery terminal.
3. Press up or down
arrow indicators and press the side arrow enter key to select the
battery test, battery type and battery rating.
4. Battery test
results will display one of the following: GOOD & PASS, GOOD
& RECHARGE, RECHARGE & RETEST, BAD& REPLACE or BAD CELL
5. Press up or down
arrow indicators and side-arrow enter key to select system test.
6. System test results
will display one of the following: CRANKING VOLTS NORMAL,
CRANKING VOLTS LOW or CRANKING VOLTS NOT DETECTED
7. Subsequent system
tests show high, low and normal charging volts at idle and with